Ubiquiti Networks PBE-M2-400 verkkoantenni Sektoriantenni 18 dBi (PBE-M2-400)
Ubiquiti Networks PBE-M2-400 verkkoantenni Sektoriantenni 18 dBi (PBE-M2-400) -arvostelut
Perustuu 9 arvosteluun
Installed for a short 1/4 mile P2P network. Shooting through some light tree limbs only loosing about 5MBS from comcast modem
Installed for a short 1/4 mile P2P network. Shooting through some light tree limbs only loosing about 5MBS from comcast modem
Ernest Lynn
21. heinäkuuta 2018
High power. My 3rd Ubiqiti device. Always impressed with the quality.
High power. My 3rd Ubiqiti device. Always impressed with the quality.
T. Davenport
2. heinäkuuta 2018
This is an amazing device. I used a tp-link cpe210 and a cpe710 with a yagi antenna. They both barely worked. This works no problem. Using it to connect to a ubiquity hotspot on my back porch from about 0.2 miles away. The noise floor is 89db, so it is a pretty difficult task to make work. There are about 30 other hotspots in the area, and about 1/3 are on the same channel. The narrow beam on this lowered the noise floor by 2db, and had 6db more signal, so I can get 15db snr. Sometimes a little less. Put the wireless settings to station, and surveyed the surrounding hotspots. Locked it to my hotspot. I then clicked on network and changed the mode from bridge to router. Be sure to enable NAT on the network page. It is not on by default. I connected a switch, and then connected my cameras. Bingo, they were on my network. Very nice device. Looks well made, we'll see how it handles the Florida weather. Looks like it will be ok.
This is an amazing device. I used a tp-link cpe210 and a cpe710 with a yagi antenna. They both barely worked. This works no problem. Using it to connect to a ubiquity hotspot on my back porch from about 0.2 miles away. The noise floor is 89db, so it is a pretty difficult task to make work. There are about 30 other hotspots in the area, and about 1/3 are on the same channel. The narrow beam on this lowered the noise floor by 2db, and had 6db more signal, so I can get 15db snr. Sometimes a little less. Put the wireless settings to station, and surveyed the surrounding hotspots. Locked it to my hotspot. I then clicked on network and changed the mode from bridge to router. Be sure to enable NAT on the network page. It is not on by default. I connected a switch, and then connected my cameras. Bingo, they were on my network. Very nice device. Looks well made, we'll see how it handles the Florida weather. Looks like it will be ok.
Scott
11. tammikuuta 2018
Works as it should. No issues so far. This is my second order. However, if you are buying two for use as PTP bridge, get the 5ghz version to reduce interference with the neighbors.
Works as it should. No issues so far. This is my second order. However, if you are buying two for use as PTP bridge, get the 5ghz version to reduce interference with the neighbors.
Jonny B
8. maaliskuuta 2017
As good as you would expect from Ubiquiti. Recommended if you need more range over the nano station m2.
As good as you would expect from Ubiquiti. Recommended if you need more range over the nano station m2.
hilo90mhz
28. helmikuuta 2017
