Fractal Design Prisma AL-12 PWM, 120mm PWM-laitetuuletin, musta/valkoinen
Fractal Design Prisma AL-12 PWM, 120mm PWM-laitetuuletin, musta/valkoinen -arvostelut
Perustuu 3 arvosteluun
Great looking and effective without too much noise
Great looking and effective without too much noise
DylsMc
26. syyskuuta 2023
They seem reasonably quiet and the lighting looks good. I bought them because of the edge lighting which looks nice in a roof mounted AIO cooler. ARGB can be daisy chained - a bit of a mess of wires behind the mobo but no hubs, no proprietary software (I used to use Corsair ...) and I only need to use one ARGB header for all 3 plus my AIO's ARGB. 4 stars because the fan cables could do to be a bit longer as passing through the mobo top to wrap round behind then plug in the bottom is hard/impossible.
They seem reasonably quiet and the lighting looks good. I bought them because of the edge lighting which looks nice in a roof mounted AIO cooler. ARGB can be daisy chained - a bit of a mess of wires behind the mobo but no hubs, no proprietary software (I used to use Corsair ...) and I only need to use one ARGB header for all 3 plus my AIO's ARGB. 4 stars because the fan cables could do to be a bit longer as passing through the mobo top to wrap round behind then plug in the bottom is hard/impossible.
Rhett B
8. toukokuuta 2023
Bought this fan to use as an exhaust on the rear of a Fractal Designs Focus-Mini G case. Uses a 3 pin A-RGB cable for the LEDs and a 4 pin PWM cable for the fan, both are nicely braided for durability. My motherboard does not have a 3 pin A-RGB header so I bought the Fractal Adjust R1 fan controller to operate the RGB LEDs (requires a SATA connection for power). Lots of patterns and colours to choose from in manual operation. Runs quiet and moves a decent amount of air out of the case in PWM.
Bought this fan to use as an exhaust on the rear of a Fractal Designs Focus-Mini G case. Uses a 3 pin A-RGB cable for the LEDs and a 4 pin PWM cable for the fan, both are nicely braided for durability. My motherboard does not have a 3 pin A-RGB header so I bought the Fractal Adjust R1 fan controller to operate the RGB LEDs (requires a SATA connection for power). Lots of patterns and colours to choose from in manual operation. Runs quiet and moves a decent amount of air out of the case in PWM.
Scott
15. lokakuuta 2019
